Ödeme & teslimat koşulları:
|Name:||Folding Fence Barrier Gate Operator For Parking Lots And Garages||Color:||Black,red,blue,white|
|Voltage:||220V±10%, 110V±10%, 50/60HZ||Rated Power:||80W|
driveway barrier gates,
folding barrier gate
Folding Fence Barrier Gate Operator For Parking Lots And Garages
WSTP-134 Barrier Gate with Automatic moisture uses the first generation motor. It is stable and has long service life performance, running five million times. Its housing is made of galvanized steel with 2mm thickness, and painted, so that the barrier can be used in door and outdoor.
1. Automatic moisture control
2. Barrier motor with die-casting aluminum alloy is high-hermetic and easy for heat dissipation
3. Motor cooling fan to avoid the over-heating possibility
4. Automatic reversing when the barrier boom meets the obstruction
5. Auto closing realization through menu setting on the control panel
6. The barrier works well with infrared photocells, loop detectors, card readers, ticket dispensers, manual switch (wire control), and traffic light
7. RS485 Communication Module
8. Traffic light interface
9. LED Screen
10. Manual release device to operate the barrier when power failure
11. Infrared Photocells (optional)
12. Support the external and internal Vehicle Loop Detector (optional)
Motor Speed and Boom Type:
|Boom type||Boom Length(M)||Opening time(S)||Height between boom and ground(M)|
Selection of spring.
|Spring type||Diameter||Spring Length|
1. Drive Motor is warranted against manufacturer’s defect for lifetime
2. Standard warranty for all components is valid for12 months from the date of delivery
3. This warranty does not include damages caused by:
a. Wear and Tear
d. Act of God & Natural Disaster
e. Unstable power supply (i.e. inconsistent voltage or lightning)
1. When barrier finish closing, why does the arm open itself slowly?
the spring is too tight, you need release the spring a little, then test it again.
see whether the main crank touch the triangle tightly or not, if tightly, adjust it.
reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal noises?
As for this, it means the resistance on controller board is broken, if you have professional tools to check,
then replace that broken resistance, if not, replace that controller panel.
3. Why does the barrier finish half operation of opening and closing?
If uses our controller panel, you only need to find resistance R37 on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of inclination?
the model is not good, and the gear doesn't fit each other tightly.
the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order control, what's the problem?
To check the loop cable first, because the loop cable maybe brokem
To check the motor sensor, if it is not set well, then reset it in the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
The spring is very tight
The Screw touches the rubber absorption tightly, need to reset again.
7. Rubber linning installation suggestion:
It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
The place with many vehicles come and go, like shopping center, carpark area.
8. Can you accept OEM/ODM order?
Absolutely, we are manufacturer of barrier gate, with 7 years researching and developing experience.
Contact us for pricelist and catalog: